When LED #1 and #3 go OFF, then the idle board has sensed a demand to weld the solenoid has released and the machine should be running at weld speed.As long as it is lit, the solenoid is pulled in and the machine is at idle. As long as it is lit, the machine is in idle-down mode: the solenoid is pulled in and the machine is at idle speed. It should never go out as long as the machine is running.
#Miller bluestar 2e welder specs Pc
As long as it is lit, the PC board has a 12-volt DC supply and a good ground. Connect the two black wires, wires #35 and #36 (auxiliary power sensing), to the blue male connectors on the Weldmart-OnlinePC board these are sensing wires and there is no polarity.Connect Miller wire #33 (12 VDC Ground) to terminal #2.Wire #37 goes to one side of the idle solenoid. Connect Miller wire #37 to one side of the auto idle switch, and connect the other side of the switch to terminal #3.Connect Miller wire #8 to terminal #1 (12VDC + when machine is running).Weldmart-OnlineIdler PC Board Connections: Miller Bluestar 2-E Schematic with Wiring Modifications Noted NOTE: The back of the board cannot come into contact with the front panel of the welder! Mount the Weldmart-OnlineIdler board in place of the Miller board with the hardware about ½ to 1 inch spacing is best. Weldmart-OnlineInstructions (This is what you are now reading!).The Weldmart-OnlineUpgrade Board Kit includes the following: This means you get an inexpensive board that is easily installed, easily repairable, and highly reliable.
0 kommentar(er)
